CSS Touring® Quick Release Awning Brackets (Set of 3)

$225.00
Minus Plus

CSS Touring® Quick Release Awning Brackets (Set of 3)


Brackets can also be made fixed if you are not wanting to use them as quick release. Please ensure that the weight of the awning is supported by at least 2 people before removing quick release pins.


Stock Levels:

Melbourne Store - Out of Stock Until Further Notice

Brisbane Store - Limited Stock Available 

Please kindly note, the ETA is subject to change due to unforeseen delays.


Standard Tent Awning Brackets suit the below Tent Models:

  • CSS Touring Standard 1.3 Roof Top Tent
  • CSS Touring Standard 1.4 Roof Top Tent

X/Pro Tent Awning Brackets suit the below Tent Models:

  • CSS Touring 1.3 Pro Roof Top Tent
  • CSS Touring 1.4 Pro Roof Top Tent
  • CSS Touring 1.3X Roof Top Tent
  • CSS Touring 1.4X Roof Top Tent


Included in the Bracket Kit:

  • 3x Awning Brackets
  • 2x Corner Braces
  • All Required Hardware


Please note, it is mandatory that your awning is tied down every time it’s in use if mounted directly to the side of your rooftop tent. 

Also kindly note that once an awning is mounted with these brackets to one of our rooftop tents, there won’t be enough clearance to open and close the side latch. In this case, you will simply need to remove the side latch to run the awning mounted directly to the side of the rooftop tent.

This is completely fine to do, you’ll just need to be mindful, as you normally would to make sure the canvas is always tucked in properly when closing the tent so there’s no fabric caught or pinched in the seal. Also, as usual, you’d need avoid overfilling the tent with bedding to ensure everything closes smoothly.

Please ensure that you select the correct type of awning bracket depending on which rooftop tent model you have.

More details Right